EPOXY FLOORINGNSW
Free quote
Charcoal flake epoxy garage floor with a high-gloss finish in Caringbah

Caringbah Epoxy Flake Garages

Vinyl chip broadcast to rejection over a pigmented base, sealed with two coats of polyaspartic. The workhorse finish for garages, laundries and workshops. We quote Caringbah jobs after we have seen the slab, never over the phone.

Build thickness
1.2–1.8 mm
Topcoat
Polyaspartic
Foot traffic
Same evening
Drive on
72 hours
Epoxy Flake Garages · Caringbah 2229

Epoxy Flake Garages done properly in Caringbah

If you are in Caringbah or anywhere else in Sutherland Shire, the assessment is free and we will tell you straight if the slab is not worth coating.

A flake floor is built in layers, not painted on. We diamond-grind the slab back to a CSP 2–3 profile, cut out and fill the cracks, roll a penetrating epoxy primer, then lay a pigmented base coat and throw vinyl chip into it while it is still wet — to rejection, so the whole floor is covered. Once it cures we knock the flake back flat, vacuum, and finish with two coats of polyaspartic.

The result is roughly 1.2 to 1.8 mm thick, seamless, and immune to the hot-tyre pickup that lifts cheap garage paint off a slab in the first summer. Oil wipes straight off it, and a soft broom is the only maintenance it needs.

What is included

  • Diamond grind and edge preparation
  • Crack and spall repair included to 5 linear metres
  • Epoxy primer plus pigmented base coat
  • Full flake broadcast in your choice of blend
  • Two-coat polyaspartic topcoat
  • Anti-slip additive available on request

The specification

Build thickness1.2–1.8 mm
TopcoatPolyaspartic
Foot trafficSame evening
Drive on72 hours
Typical job2–3 days

How the job runs in Caringbah

  1. We come to Caringbah, measure the area, moisture-test the slab and photograph anything that needs repair.
  2. You get a written quote within two business days with preparation, repairs and coats itemised separately.
  3. On day one we diamond-grind the surface back and cut out the cracks, with dust extraction running throughout.
  4. The system goes down in coats, each one checked with a wet film gauge before the next.
  5. We hand back a clean floor with the colour, batch numbers and cure times written down for your records.

Questions we get in Sutherland Shire

How long before I can park on it?

Foot traffic the same evening the topcoat goes down, vehicles at 72 hours. That figure is not negotiable — driving on a green coating imprints hot tyre marks that never lift.

Will it peel like my last garage floor?

Only if the preparation is skipped. Coatings peel because they went over a sealed, acid-etched or damp slab. We grind mechanically and moisture-test before quoting, which removes the two causes behind almost every failure we are called out to fix.

Can I choose the flake colour?

Yes. We bring the full colour chart to the site assessment and match the blend against your walls, joinery and roller door in the light the floor will actually live in.

How soon can you look at my job in Caringbah?

Usually within two or three business days. The assessment takes about 45 minutes — we measure up, probe the slab for moisture and photograph any cracks — and the written quote follows within two business days of that.

Nearby

Epoxy Flake Garages near Caringbah

We cover Sutherland Shire and the surrounding areas. Same crew, same preparation standard, no travel loading inside the metro area.

Epoxy Flake Garages in Caringbah — Book Your Free Assessment

Free on-site assessment across Sutherland Shire — Mon–Sat, 6:30am–5pm.